How to replace a glass lifter switch? – spare parts

Steps of replacing a glass lifter switch:

1. Open the door where the switch needs to be replaced, and locate the gap at the joint of the trim panel and the door panel;

2. Insert the prepared tool into the gap and pry up the trim panel. Take out the trim panel along the gap;

3. Hold up the trim panel and remove the plug of the lifter switch;

4. Turn the trim panel upside down. Loosen the small fixing screws of the switch, and take down the lifter switch;

5. Install a new lifter switch. Tighten the screws and insert the plug;

6. Test the lifting function, and re-install the trim panel after confirming normal function of the switch.

Possible reasons for unsmooth glass lifting:

1. Aged glass rubber or dust accumulation;

2. Too much dirt or presence of foreign matters in the glass guide slot;

3. Failure of a glass lifter component.

How to replace a glass lifter switch? - spare parts
How to replace a glass lifter switch? – spare parts

Name: glass lifter switch/single

Ref No. : 1J3959857A

Product system: electrical

Brand: vika

Applicable models:

Seat: FAB00-08/OCT01-11

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close