03L115562 oil filter element replacement method

Replacement of the filter element of a single-barrel pre-filter:

1. Close the oil inlet ball valve and open the upper end cover (an aluminum alloy upper end cover should be prized up gently from side gap with a slotted screwdriver);

2. Screw off the drain outlet plug, and drain the waste oil completely;

3. Loosen the fixing nut on top of the filter element. The operator should wear a pair of oil-proof gloves and hold the filter element tightly whiling lifting it up and removing it vertically;

4. Install a new filter element. Put the top sealing ring in place (an integrated gasket is provided at the bottom), and tighten the nut. Tighten the drain outlet plug, replace the end cover (the gasket should be properly placed), and install the fixing bolt.

Replacement of the filter element of a parallel double-barrel pre-filter:

1. First close the oi inlet valve on the side where the filter element needs to be replaced. Wait for a couple of minutes before closing the oil outlet valve. Next, screw off the end cover screws and open the end cover;

2. Open the drain valve and drain the waste oil completely to prevent it from entering the clean oil chamber during replacement of the filter element. Loosen the fixing nut on top of the filter element. The operator should wear a pair of oil-proof gloves and hold the filter element tightly whiling lifting up the filter element and removing it vertically;

3. Install a new filter element. Put the top sealing ring in place (an integrated gasket is provided at the bottom), and tighten the nut;

4. Close the drain valve. Replace the end cover (the gasket should be properly placed), and install the fixing bolt.

5. Open the oil inlet valve and the exhaust valve in turn. When oil appears from the exhaust valve, close the valve immediately, and then open the oil outlet valve. Repeat the above steps for the filter on the other side.

03L115562 oil filter element replacement method
03L115562 oil filter element replacement method

Name: oil filter element

Ref No. : 03L115562

Product system: engine

Brand: vika

Applicable models:

Skoda: FAB11-15/OCT09-13/RAP13-;12-/RO11-15/SUP08-13;/YET10-13;14-

VW: AMA10-13/BE12-13/CA11-16/CAMP10-16/CC12-/CR12-/EOS11-16/GO09-14/IMD08-/JE06-15/PA09-15/PO10-15/SCI09-12/SHA11-16/TIG08-12/TOU11-15/TR10-16

Seat: A1 11-14/A3 08-13/A4 08-16/A5 12-/A612-14/ATT11-14

Audi: AL11-15/ALT07-10;11-13;14-15/EX09-14/IB09-11;12-12;13-/LE06-10;11-13/TO13-15

By continuing to use the site, you agree to the use of cookies. more information

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close